ΠΑΚΕΤΟ ( ROMAN ) - ΠΩΣ ΝΑ ΜΕΤΡΗΣΕΤΕ - ΤΟΠΟΘΕΤΗΣΕΤΕ ΤΗΝ ΚΑΤΑΣΚΕΥΗ
Buying a roman presupposes the measurement of the position of installation. How to measure a window to install a Roman ( packet ) ; We will need a metal meter ( not tape ) , a notes block and of course a pencil .
Where our opening is a window << flush >> i.e. the window is recessed into the wall. In that case the package will sit within the narrow limits of the window. So here we measure the height B - width C and A - B. Attention should not make the slightest error in measurement because otherwise the package may fall short the strait or in the worst case ... .to not fit into the frame. Here we have the ease of installation of the device because the device mount directly beneath the frame or with two special brackets which will procure from where you will buy the the 2 simple screw mechanism (6ares the 5ares) together with their plugs.
This placement is at the desired point concerning the mechanism . Usually measured over the frame of the window 0.10 to 0.20 points. The receiver is wide and is normally 0.07 to 0.10 points away from the frame of the window on the left and right so that our package covering the frame of the window.
Now as regards the level of our package ... .. with this very personal matter of meters each . We may want the package ( the lowest point ) is almost up down - which is not so common because maybe need to put a couch - or 0.15 to 0.20 under the frame of the window , which is the most common method . This placement will become two angles , depending on how out exits the window handle, of 0.08 to 0.15 points.